[[PageOutline]] = Enclosures = Gateworks sells a variety of enclosures on their online shop seen here: [http://shop.gateworks.com/index.php?route=product/category&path=76 Gateworks Online Shop - Enclosures] == Newport Indoor Enclosures * The Newport Indoor Enclosures are built slightly taller to accomodate the fansink that is on the Newport SBCs. Additionally the side plates have holes for venting / cooling. All Newport enclosures can be seen: [https://shop.gateworks.com/index.php?route=product/category&path=76_77_93 Gateworks Newport Enclosures] == Indoor Ventana Enclosures == === Installation Instructions === * Heatsink * The enclosures are designed to heatsink the processor on the SBC to the metal enclosure for better heat dissipation. This is optional and a choice of the customer. The enclosure is supplied with a solid aluminum block. To use this, remove any heatsink currently on the processor and replace with the aluminum block heatsink as shown in the picture below: * [[Image(enclosureheatsink.jpg,400px)]] * Mounting SBC * Remove front plate of enclosure and pull out bottom plate that has standoffs on it. * Place the board 'upside down' on the standoffs and screw in 4 screws as shown below * [[Image(enclosurestandoffs.jpg,400px)]] * Remove front plate of enclosure and slide in bottom plate and board as shown below: * [[Image(enclosurefront.jpg,400px)]] * Re-attach front plate and see the final product: * [[Image(enclosure.jpg,400px)]] === Din Rail Clip === The Ventana Indoor enclosures can be fitted with a DIN Rail clip Two holes have been slightly punched to allow for customer drilling. Din Rail Clip: [http://shop.gateworks.com/index.php?route=product/product&product_id=162 GW10092] Screws to mount to enclosure are DIN74-Am4 which means a 90Deg countersink, with 4mm Metric screw. These can be seen here: [http://www.mcmaster.com/#92010a216/=x61x47 Example Screw] Drill bit size: 11/64th or !#18 drill bit [[Image(enclosuredinholes.jpg)]] == Hazardous Enclosures / Third Party Enclosures Abtech creates off the shelf enclosures that have been used before with Gateworks SBCs. * [https://www.abtech-inc.com] * The Zag models are pretty popular and they can make cutouts like SMA's, Ethernet, etc... * [https://www.abtech-inc.com/products/enclosures/industrial-enclosures/marine-grade-aluminium-enclosure-zag.html] == Labels & Customizing Gateworks understands there are times when a custom labeled enclosure is needed. The following options exist: * Remove the top plate that shows the Gateworks logo and flip it around so the back side shows and the Gateworks logo can't be seen * Have a custom made label with adhesive backing custom made and place on top of the Gateworks logo (read more below) * Contact Gateworks Sales Team directly to have a custom enclosure made with your company logo. This usually requires a minimum of at least 100 pieces and will require a setup fee, typically starting around $450 but could vary. ==== Custom Adhesive Label There are scenarios where a label / sticker can be applied to the standard Gateworks indoor enclosures for company branding. In the past, Gateworks customers have used labels with the following properties: * Label Material: Textured Polycarbonate Laminate - scratch resistant, scuff resistance and UV resistance. * Adhesive: Permanent Adhesive * Thickness: 6mil (.006 inch) total * Corners: Square, NON-Rounded * Size: Measured to fit on top panel of enclosures. Size will vary depending on enclosure size, taken into account the corner pieces. * Vendor: [https://www.lolareddesign.com/]