| 20 | | 1. Connect GW16122 to Gateworks SBC |
| 21 | | 2. Connect antenna to GW16122 |
| 22 | | 3. Install Ubuntu for Gateworks SBC |
| 23 | | 4. Install Ti 15.4 Stack on Gateworks board |
| | 20 | * Connect GW16122 to Gateworks SBC |
| | 21 | * Connect ethernet cable to Gateworks SBC on the same network as a PC/Laptop (for web gui viewing) |
| | 22 | * Connect antenna to GW16122 |
| | 23 | * Install Ubuntu for Gateworks SBC |
| | 24 | * Install Ti 15.4 Stack on Gateworks board |
| | 25 | * Run the script on the Gateworks command line: ./run_demo.sh with the following output: |
| | 26 | {{{ |
| | 27 | |
| | 28 | }}} |
| | 29 | * Observe the IP address printed out in the script output |
| | 30 | * From a computer on the same network as the Gateworks board, open a web browser and type in the IP address including the port and observe the web gui shown below: |
| | 31 | [[Image(gw16122webgui.png,400px)]] |
| | 32 | * Power on the sensor node that should connect to the collector. |
| | 33 | * NOTE: The sensor node has NV Ram that stores the last network it was connected to. This must be reset every time the run_demo.sh script is ran. |
