Changes between Version 3 and Version 4 of enclosures


Ignore:
Timestamp:
08/09/2018 11:37:47 PM (16 months ago)
Author:
Tim Harvey
Comment:

remove avila/cambria/rincon data

Legend:

Unmodified
Added
Removed
Modified
  • enclosures

    v3 v4  
    3333
    3434== Gateworks GW3021 IP67 Outdoor Enclosure ==
    35 The GW3021 enclosure is IP67 rated enclosure for outdoor installations of Gateworks 4x4 and 4x6 Avila, Cambria, Laguna, Newport and Ventana network processing boards. The GW3021 provides complete protection against the ingress of dust (6) and water when immersed to 1m for up to 30 minutes (7). The enclosure includes four antenna connectors and two shielded weatherproof RJ-45 Ethernet connectors. The antenna connectors are located at the four corners to increase spatial diversity and decrease RF grounding to the mounting mast. Power is supplied to the unit through the Ethernet connector using a passive PoE injector or PoE power supply. The enclosure includes a pole mount bracket, processor heat sink and a long life, ball bearing fan to reduce thermal hot spots by circulating the air inside the enclosure. The enclosure comes fully assembled and ready to go with all mounting hardware.
     35The GW3021 enclosure is IP67 rated enclosure for outdoor installations of Gateworks 4x4 and 4x6 Laguna, Newport and Ventana network processing boards. The GW3021 provides complete protection against the ingress of dust (6) and water when immersed to 1m for up to 30 minutes (7). The enclosure includes four antenna connectors and two shielded weatherproof RJ-45 Ethernet connectors. The antenna connectors are located at the four corners to increase spatial diversity and decrease RF grounding to the mounting mast. Power is supplied to the unit through the Ethernet connector using a passive PoE injector or PoE power supply. The enclosure includes a pole mount bracket, processor heat sink and a long life, ball bearing fan to reduce thermal hot spots by circulating the air inside the enclosure. The enclosure comes fully assembled and ready to go with all mounting hardware.
    3636 * Note fan connector was designed for Laguna SBCs. For other board families, please cut wires and install appropriate connector.
    3737 * Note: GW10091 Adapter plate required for Ventana/Newport SBCs, shown [#GW10091 below]