Changes between Version 20 and Version 21 of jtag_instructions


Ignore:
Timestamp:
02/14/2019 09:55:32 PM (7 months ago)
Author:
Cale Collins
Comment:

changed 16042 to 16099, added note to troubleshooting 16042 and adapter fail when flashing newport.

Legend:

Unmodified
Added
Removed
Modified
  • jtag_instructions

    v20 v21  
    22
    33= JTAG USB User's Guide =
    4 The [http://shop.gateworks.com/index.php?act=viewProd&productId=56 Gateworks GW16042 JTAG Adapter] is used for flashing firmware to Gateworks Boards as well as serial console access.
     4The [http://shop.gateworks.com/index.php?act=viewProd&productId=56 Gateworks GW16099 JTAG Adapter] is used for flashing firmware to Gateworks Boards as well as serial console access.
    55
    66The device is primarily used used to access Gateworks devices for debugging and developing purposes.
     
    1111
    1212References:
    13  * [http://shop.gateworks.com/index.php?act=viewProd&productId=56 GW16042 on Gateworks on-line store]
     13 * [http://shop.gateworks.com/index.php?act=viewProd&productId=56 GW16099 on Gateworks on-line store]
    1414 * [http://dev.gateworks.com/jtag/ Gateworks JTAG Utilities]
    1515
     
    297297 4. While programming, if it gets stuck at "Load Debugger: fS3' or fS2, this may mean there are issues with the GSC.  Please re-flash the GSC firmware as demonstrated here: http://trac.gateworks.com/wiki/gsc#GSCUpdates
    298298 5. Ground loops can occur between the board power supply and the JTAG cable. Be aware of this and isolate properly.
     299 6. GW16042 with 10 > 14 pin adapter board will flail to flash Newport boards.  Serial console is verified to work. 
    299300
    300301If still have difficulties, please contact Gateworks support at !support@gateworks.com