Changes between Version 27 and Version 28 of FSA

Timestamp:

02/09/2026 06:52:45 PM (34 hours ago)

Author:

Tim Harvey

Comment:

clarified ath12k requirements

FSA

@@ -1249 +1249 @@
  * ath12:
   * firmware: ath12k/QCN9274/hw2.0
-   - board-2.bin and firmware-2.bin (from https://git.codelinaro.org/clo/ath-firmware/ath12k-firmware; several options for firmware-2.bin all which work accept for QCN9274/hw2.0/testing/1.4.1/WLAN.WBE.1.4.1-00103-QCAHKSWPL_SILICONZ-1/firmware-2.bin)
+   - board-2.bin and firmware-2.bin (from either [https://git.kernel.org/pub/scm/linux/kernel/git/firmware/linux-firmware.git/ linux-firmware.git] or [https://git.codelinaro.org/clo/ath-firmware/ath12k-firmware ath12k-firmware]
    - regdb.bin and board.bin (not publicly available and are provided by Compex :sales@compex.com.sg)
   * driver:
@@ -1278 +1278 @@
 .0/0000:01:00.0/0000:02:05.0/0000:07:00.0/net/wlan1
 }}}
- * There is a patch posted (not accepted yet) which fixes the 'Invalid module id2' 'failed to parse tlv -22' issue (https://patchwork.kernel.org/project/linux-wireless/patch/20231030222700.18914-2-quic_rajkbhag@quicinc.com/)
- * Note that additional cma is needed (cma=196M) for this card
- * Note that Linux 6.9 or newer is likely required (tested 6.9, 6.10, 6.11, 6.12-rc6; 6.6 is too old, not sure about 6.7, 6.8)
- * iperf3 showed TX/RX rate of 503/499 mbps
+    * Note the 'Invalid module id2' 'failed to parse tlv -22' messages are not failures
+    * Note that additional cma is needed (cma=100M at least) for this card
+    * Note that Linux 6.9 or newer is likely required (tested 6.9, 6.10, 6.11, 6.12-rc6; 6.6 is too old, not sure about 6.7, 6.8)
+ * OS support:
+  - Gateworks Ubuntu rootfs based BSP (6.12, 6.18 kernels)
+  - Gateworks OpenWrt 24.10 BSP (6.6 kernels)
+  - Gateworks OpenWrt 25.12 BSP (6.12 kernels) 
+ * Performance:
+  - iperf3 showed TX/RX rate of 503/499 mbps