Changes between Version 22 and Version 23 of canbus

Timestamp:

06/19/2026 09:35:07 PM (84 minutes ago)

Author:

Ryan Erb

Comment:

add connector

canbus

@@ -86 +86 @@
   * CAN2_TXD pin 5
 
+
 For connecting a cable to the MIPI connector the GW16145 breakout adapter can be used. For more info on this adapter see this link [https://trac.gateworks.com/wiki/venice/mipi#GW16145MIPIMediaBreakoutboard GW16145 Breakout Board]
 
 Note the Termination resistor options in the table above and remember that a properly terminated CAN network will have 120ohm termination across CAN_L and CAN_H at each end of the bus for a total measured resistance of 60ohm.
 
+=== Connectors
+
+Connectors are defined in the hardware user manuals located here: [https://www.gateworks.com/support/documentation/]
+
+For the GW8200 and GW9200:
+Dual Isolated CAN Bus is available through a 5-pin header in a 1x5 configuration with 2mm spacing. The mating connector is a TE Connectivity 1-2350224-5. The mating connector pins are TE Connectivity 2350223-1.
 
 [=#stby]