Changes between Version 30 and Version 31 of gps


Ignore:
Timestamp:
11/20/2026 08:14:25 PM (10 hours ago)
Author:
Ryan Erb
Comment:

antenna updates

Legend:

Unmodified
Added
Removed
Modified
  • gps

    v30 v31  
    142142 * Communication:
    143143  - 38400 baud, 8 data bits, no parity, 1 stop bit
     144
     145==== MIA-M10 Antenna Information
     146
     147The MIA-M10 is configured to work with the following:
     148 * 3.3v active antenna
     149 * L1-band support
     150 * 50 ohm
     151 * Gain: The max antenna gain would be 30dB in low gain mode (default) and between 10 and 40 dB in bypass mode. The MIA has an internal LNA. Thus for certain antennas, this LNA may be needed to put into bypass mode. Configure the MIA-M10Q's internal LNA to LOWGAIN or BYPASS mode via UBX configuration (CFG-HW-ANT_CFG / internal LNA mode) to prevent front-end saturation and reduce power draw.
     152
     153If a passive antenna is needed, the resistor to the 3.3V rail would need to be unloaded at time of manufacturing (100 piece minimum order) otherwise damage / shorting could occur.
     154
     155A suggested antenna is the u-blox ANN-MB5-00
     156 * Digikey link: [https://www.digikey.com/en/products/detail/u-blox/ANN-MB5-00/21528521]
     157 * Magnetic mount
     158 * L1/L5 bands
     159 * Requires a SMA to MMCX adapter cable.
     160
     161Sample antenna schematic circuit below for all Venice / Catalina products:
     162 * [[Image(miagpsant.jpg,400px)]]
     163
    144164
    145165
    … …  
    310330[=#antenna]
    311331== Antennas ==
     332
     333Gateworks Venice and Catalina families are designed to be used with active antennas (3.3v) which typically get better reception than passive antennas.
     334
    312335GPS receivers can use active or passive GPS antennas. An active antenna is powered and uses an LNA (Low Noise Amplifier) at the antenna instead of at the GPS receiver making it more sensitive than a typical passive antenna.
    313336
    314 Some of the GPS modules can be used with passive antenna. See the modules datasheet for more information. Gateworks provides 3.3V for the active antenna DC voltage on all boards.
     337Some GPS modules can be used with passive antenna with a special configuration. See the modules datasheet for more information. Gateworks provides 3.3V for the active antenna DC voltage on all boards.
    315338
    316339Gateworks typically uses a 50 ohm MMCX connector on it's board however as a special configuration a U.FL connector can be loaded in the same location.