Changes between Version 5 and Version 6 of venice/gw7905

Timestamp:

05/24/2023 06:34:48 PM (18 months ago)

Author:

Ryan Erbstoesser

Comment:

add table

venice/gw7905

@@ -74 +74 @@
 === J3 GPIO Expansion
 
-A 2x10 connector (20 pins total) that supports a variety of signals as defined in the screenshot below. 
+A 2x10 connector (20 pins total) that supports a variety of signals as defined in the table below. 
 
 The connector is a 20-pin header in a 2x10 configuration with 1.25mm pin spacing. The mating connector is a JST GHDR-20V-S, available from Digi-Key as part number 455-1913-ND. The mating connector pins are JST SGHD-002GA-P0.2, available from Digi-Key as part number 455-1914-2-ND. The digital I/O signals include signal conditioning in the form of a series 332 ohm resistor.
@@ -80 +80 @@
 A dev kit cable is the GW10127: [https://shop.gateworks.com/index.php?route=product/product&product_id=214&search=20]
 
-[[Image(7905j3.png,300px)]]
+|| GW7905 || J3.1  || VDD_3P3 || - || - || - || ||
+||        || J3.2  || GND     || - || - || - || ||
+||        || J3.3  || VDD_3P3 || - || - || - || Opt UART2_TX ||
+||        || J3.4  || GND     || - || - || - || Opt UART2_RX ||
+||        || J3.5  || SPI_MOSI || ECSPI2_MOSI ||  || managed by SPI driver ||  ||
+||        || J3.6  || SPI_MISO || ECSPI2_MISO ||  || managed by SPI driver ||  ||
+||        || J3.7  || SPI_SCLK || ECSPI2_SCLK ||  || managed by SPI driver ||  ||
+||        || J3.8  || SPI_SS0  || ECSPI2_SS0  ||  || managed by SPI driver || ||
+||        || J3.9  || I2C3_SCL || I2C3_SCL    ||  || managed by I2C driver ||  ||
+||        || J3.10 || I2C3_SDA || I2C3_SDA    ||  || managed by I2C driver ||  ||
+||        || J3.11 || GSC_ADC1 || - || ||  || Can measure 0 to 5V ||
+||        || J3.12 || GSC Tamper ||  ||  ||    || ||
+||        || J3.13 || GPIOA || GPIO1_IO13 ||  ||    || [wiki:venice/DigitalIO Venice DIO Info] ||
+||        || J3.14 || GPIOB || GPIO1_IO14 ||  ||    || ||
+||        || J3.15 || GPIOC || GPIO5_IO04 ||  ||    || ||
+||        || J3.16 || GPIOD || GPIO5_IO05  ||  ||    || ||
+||        || J3.17 || 5V Fan PWR ||  ||  ||    || ||
+||        || J3.18 || GND     || - || - || - ||  ||
+||        || J3.19 || GSC FAN PWM ||   ||  ||  || ||
+||        || J3.20 || GSC FAN Tach ||   ||  ||  || [wiki:gsc GSC Fan Info] ||
 
 === J2 GPS Antenna