Changes between Version 27 and Version 28 of expansion/gw16167


Ignore:
Timestamp:
02/18/2026 06:15:20 PM (2 days ago)
Author:
Ryan Erbstoesser
Comment:

add more troubleshooting

Legend:

Unmodified
Added
Removed
Modified

  • expansion/gw16167

    v27 v28  
    965965325b:8100 Morse Micro MM81xx Wi-Fi HaLow 802.11ah Transceiver
    966966}}}
    967   * If the device is not enumerating on the usb bus, then you should verify that your M.2 W_DISABLE1# (pin 56) and W_DISABLE2# (54) are logic high. Both of these pins have pull-up resistors on our card (200k for W_DISABLE#1 and 10k for W_DISABLE#2) so make sure you are not driving them low and do not have an on-board pull-down on your hardware.
     967  * If the device is not enumerating on the usb bus, then you should verify that your M.2 W_DISABLE1# (pin 56) and W_DISABLE2# (54) are logic high. Both of these pins have pull-up resistors on our card (200k for !W_DISABLE#1 and 10k for !W_DISABLE#2) so make sure you are not driving them low and do not have an on-board pull-down on your hardware.
     968  * If you do not see the mm8108 enumerate on the USB bus, it could be that something is driving your PERST# signal low which would keep the mm8108 on the GW16167 in reset. You can verify this with a scope/meter on the PERST# signal.
     969  * Verify with another card that USB 2.0 on the miniPCIe socket works.
    968970 * Be sure the output of command: '''dmesg | grep morse''' is a similar output to that in the driver section on this wiki page
    969971 * Install the latest Ubuntu software from dev.gateworks.com (Venice details here: [wiki:venice/firmware]