Changes between Version 138 and Version 139 of gsc

Timestamp:

11/05/2026 11:32:57 PM (28 hours ago)

Author:

Ryan Erb

Comment:

adjust tamper terms

gsc

@@ -1025 +1025 @@
 Some boards have a ''Tamper Detect'' circuit implemented either as a physical pushbutton on the board and/or a header that can have an external switch wired to it. The circuit implemented is a ''normally open'' switch to board ground (GND). 
 
-For these boards you can enable the GSC's ''Tamper Detect'' feature by setting [#gsc_ctrl_0 TAMPER_DETECT (R0.5)] and the accompanying interrupt enable register bit [#gsc_interrupt_enable IRQ_TAMPER_DETECT (R11.5)]. Once these bits are set any tamper event produced by a switch closing and the signal conducting to board ground will do the following:
+For these boards you can enable the GSC's ''Tamper Detect'' feature by setting [#gsc_ctrl_0 TAMPER_DETECT (R0.5)] and the accompanying interrupt enable register bit [#gsc_interrupt_enable IRQ_TAMPER_DETECT (R11.5)]. Once these bits are set any tamper event produced by a switch opening and the signal not conducting to board ground will do the following:
  1. Set [#gsc_interrupt_status IRQ_TAMPER_DETECT (R10.5)] interrupt status bit
  2. Erase the '''Secure Key''' EEPROM section