Changes between Version 14 and Version 15 of venice/errata

Timestamp:

09/07/2023 04:34:44 PM (15 months ago)

Author:

Ryan Erbstoesser

Comment:

update VN8

venice/errata

@@ -178 +178 @@
 
 [=#VN8]
-== VN8 GSC Battery Voltage 
+== VN8 Low GSC Battery Voltage Causes Board Not to Power On
 
 Issue:
@@ -185 +185 @@
 
 Workaround:
-
- * Disable GSC R0.7 so that a CPU reset (as in a U-Boot reset command, a Linux shutdown command, a Linux reboot command, and a CPU watchdog reset) only performs a warm boot and not a cold boot. One way to easily adjust this bit is with a i2c command in the bootloader as follows:
-{{{
-        i2c dev 0 && i2c mw 0x20 0 1 && i2c mw 0x20 0x1f 0xa1
-}}}
  
- * Note if the board is in this non-powered condition, the GSC battery can be removed to allow the board to be re-powered and gain access to the bootloader
-Resolution:
-
- * For affected products, a GSC firmware update will be issued in the future which defaults this bit to warm boot. This update is recommended for all Venice board revisions.
+ * Remove the GSC Battery
+
+Resolution:
+
+ * This will be resolved in future hardware revisions. For affected products, a GSC firmware update will be issued in the future. This update is recommended for all Venice board revisions.
 
 Affected Products: