Changes between Version 11 and Version 12 of expansion/gw16167

Timestamp:

01/21/2026 10:36:21 PM (43 hours ago)

Author:

Ryan Erbstoesser

Comment:

adjust note for latest software and troubleshooting

expansion/gw16167

@@ -96 +96 @@
 
 === Pre-Built Software Images
-The MM8108 driver from MorseMicro is supported in our latest pre-built images for the Gateworks Single Board Computers:
+The MM8108 driver from !MorseMicro is supported in our latest pre-built images for the Gateworks Single Board Computers. If using a SBC with software already installed, it is important to install the very latest from the dev.gateworks.com server below:
  * [https://dev.gateworks.com/venice/images/noble-venice.img.gz noble-venice.img.gz] (see [http://trac.gateworks.com/wiki/venice/firmware#disk-images compressed-disk-image])
  * [https://dev.gateworks.com/venice/kernel/linux-venice.tar.xz linux-venice.tar.xz Kernel tarball] (see [http://trac.gateworks.com/wiki/linux/kernel#install kernel-tarball install])
@@ -341 +341 @@
 Kernel Messages:
 {{{#!bash
-# dmesg | grep mmc0
-[    1.009160] mmc0: SDHCI controller on 30b40000.mmc [30b40000.mmc] using ADMA
-[    1.029119] mmc_sdio_init_card mmc0 quirks=0x0 ocr_card=0x300000 (1.8v=1)
-[    1.052784] mmc_sdio_init_card mmc0 setting voltage to 1.8V
-[    1.166152] mmc0: new high speed SDIO card at address 0001
-# cat /sys/bus/mmc/devices/mmc0:0001/{vendor,device)
-0x325b
-0x0306
+# lsusb
+325b:8100 Morse Micro MM81xx Wi-Fi HaLow 802.11ah Transceiver'
 # modprobe mac80211
 # modprobe dot11ah
@@ -926 +920 @@
   - The above shows the majority of the packets are using MCS9, the highest rate for the mm8108.
 
-
+== Troubleshooting
+ * Be sure you are using the absolute latest software from dev.gateworks.com
+ * Be sure you see the device on the usb bus with the lsusb command:
+{{{
+lsusb
+325b:8100 Morse Micro MM81xx Wi-Fi HaLow 802.11ah Transceiver' 
+}}}