Changes between Version 16 and Version 17 of wireless/modem/AMITMDG

Timestamp:

02/28/2022 10:39:56 PM (3 years ago)

Author:

Ron Eisworth

Comment:

--

wireless/modem/AMITMDG

@@ -25 +25 @@
 = Hardware setup
 
-== MDG100
+== MDG100 Installation
 
 Install the SIM on the backside of the modem, the bracket slides then opens like a book.  Pads on the SIM face contacts on the carrier, close then slide to lock in place.  Attach your antennas, the modem PCB is labeled next to the U.FL connectors, look for the box labeled "CON1" (a jewelers loop may be required to read).  
@@ -33 +33 @@
 Configure your SBC with the latest Ubuntu image (in the example Newport-Focal was used).  
 
-== MDG200
+== MDG200 Installation
 
-This Modem consists of two pieces, a mPCI-e adapter board, and the modem itself.  
+This Modem consists of two pieces, a mPCI-e adapter board, and the modem module.   
 
-To install, insert your SIM into the bottom side of the modem.  
+To install see the following instructions:
 
-Attach the adapter board to your SBC with the hex screws as shown below:
+1. Insert your nanoSIM into the nanoSIM socket on the bottom side of the modem module. 
+2. Attach the adapter board to the SBC with the two hex male/female standoffs as shown below. 
 
 [[Image(amitbaseboard.png, width=400)]]
 
-Plug the modem into the connector and screw it down to the baseboard:
+3. Plug the modem module into the connector on the adapter and then using the two screws secure it to the adapter board as shown below. 
 
 [[Image(amitmounted.png, width=400)]]
 
-Finally attach your antennas. 
+4. Attach your antennas. Two I-PEX connectors are used for external LTE antenna and one I-PEX connector is used for an external GPS antenna. 
 
 == Antennas